|
Delphi Diesel False Actuator Kit
Delphi is a world leader in the development and service of Common Rail diesel fuelling systems. In fact, Delphi has now taken Common Rail diagnostics even further with the launch of the False Actuator Kit (YDT410).
The False Actuator Kit is a unique piece of diagnostic equipment. The kit has been designed to work in conjunction with the sealed rail kits (YTD278 & YTD410) to further interrogate the pump when a reduction in the pressure being generated within the Common Rail system has been identified.
Once again Delphi has made certain that this tool is a great investment for the workshop by ensuring the False Actuator Kit is suitable for use on all makes of Common Rail systems including Delphi, Bosch, Denso and Siemens. The Delphi Sealed Rail Kit identifies on-vehicle the individual components of a Common Rail system that are failing. The False Actuator Kit will support with specific diagnostics of fuel pump failures. Both kits provide a low cost, all makes diagnostic solution for mechanical faults on light duty Common Rail vehicles.
Simple Fault Identification
When maximum pressure cannot be generated using the Sealed Rail Kit and the vehicle actuator, the false actuator is fitted in order to enable the pump to generate full system pressure. If the pump generates the correct pressure with the false actuator in place then the vehicle actuator is deemed to be at fault and should be replaced. If the pressure is still below the required level when tested with the false actuator then there is a mechanical failure within the pump. Delphi will supply a series of all makes test data for each actuator in order that the user can be fully confident in the diagnostic results.
The False Actuator Kit must only be used when the Sealed Rail is fitted to the vehicle. the use of false actuators without the Sealed Rail leads to extremely high pressures being generated by an uncontrolled system and poses a severe safety risk.
Systems covered:
Delphi DFP1 & DFP3
Bosch CP1 & CP3
Denso HP1 / HP2 & HP3
Siemens DCP Type 1 & DCP Type 2
False Actuator Kit At A Glance
The False Actuator Kit gives the capability to isolate actuator faults and mechanical faults on Common Rail pumps made by all major manufacturers.
|
